APPA 39T Manuel d'instructions

AC/DC CURRENT TRANSDUCER INSTRUCTION MANUAL APPA 39T 

9  THIS INSTRUMENT MUST NOT BE USED ON UNINSULATED CONDUCTORS AT A VOLTAGE GREATER THAN 1000V ac/dc. 3-2 AC Current Measureme

10 3-3 DC Current Measurement 1. Select the highest anticipated input (1000A or 100A) by the function switch. 2. Insert the “Output plugs (red and b

11 Figure 2 CURRENT

12 MAINTENANCE  TO AVOID ELECTRICAL SHOCK REMOVE TEST LEADS BEFORE OPENING THE COVER. General Maintenance 1. Repairs or servicing not converted

13 9V Battery Figure 3 9V Battery

APPA TECHNOLOGY CORP. 9F.119-1 Pao-Zong Rd., Shin-Tien, Taipai, 23115, Taiwan, R.O.C. P.O.Box. 12-24 Shin-Tien, Taiwan. Tel : 886-2-9178820 Fax : 886-

1 INTRODUCTION 1-1 Unpacking and Inspection Upon removing your new Clamp Meter from its packing, you should have the following items: 1. Current

2 Symbols in this Manual  This symbol indicates where cautionary or other information is found in the manual. = Battery 1-3 Front Panel Ref

3 Figure 1

4 SPECIFICATIONS 2-1 General Specifications Position Error : +/- 1% of Reading. Type Of Sensing : Hall effect sen

5 2-2 Environmental Conditions : Indoor use. Maximum Altitude : 2000 Meter Installation Category : IEC 1010 1000V CAT. III. Pollution D

6 2-3 Electrical Specifications All at 23ºC ± 5ºC, less than 75% R.H. Ranges : 0 ~ 100A/1000A AC

7 (2) AC Current : Ranges : 100A, 1000A Output Voltage : 10mV / A for 100A Rang

8 OPERATION This instrument has been designed and tested in accordance with IEC Publication 1010, Safety Requirements for Electronic Measuring App