APPA 33II Manuel d'instructions télécharger pdf (Page 13)

3-3 AC Voltage Measurement

1. Set the function switch at " V ~ " position.

2. Connect the black test lead to the "COM" terminal and the red test lead to the " V-Ω" terminal.

You can now place the test probes on the conductors to make the measurement.

3-4 Resistance Measurement

1. Set the function switch at " Ω " position.

2. Connect the black test lead to the "COM" terminal and red test lead to the " V– Ω " terminal.

3. Verify that the power to the circuit under test is off. Connect test leads to the circuit to make the measurement.

4. Built in buzzer sounds if the resistance of the circuit under test is less than approximately 50Ω.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

APPA 33II Manuel d'instructions Page 13